Found where is my 1-wire Problem !
Now i explain why i have problem with my 1-wire barometer.
After few days i found one transformer from any pc device(i don’t from what, but over side write ” 14V 0.8A” ) and i decide to make this transformer to supply my 1-wire barometer ..
And i put to this divice jack and power my 1-wire barometer and what happed !?
When I run OneWireViewer i found ALL is OK and program no say anythings Errors !!
All with 1-wire converter DS9097E !!!
Then I run Wserver and determinate - All Work very fine and program not say ANYTHING ERRORS !!!
Even Wserver read and DS18S20 !! I don’t believe because creator of this program sayd me .
quote: I’m not sure about the DS2438 and external power - but I _KNOW_ it will not read a DS1820 temperature sensor if it’s connected through a DS9097E !
This is e-mail is send from ARNE !
That’s ALL
Now i coment that circuit and pcb what i make !!
First thing is that when power supply to 1-wire barometer is supply with 20V and more. The stabilizer begin heat up and the stabilizer MUST be put over aluminium or other cooler ! But effect of that heating is very BAD.
Thermo sensors display not really temperature and not showing accurate temperature !!
And issue is supply barometer with 12-14V and u don’t have a problems with accurate measuring of temperature !
I will stop now and go to sleep :)